Double Wire Jewelry Hook

Bend the Wire Hook Again

Double Wire Jewelry Hook

Tammy Powley

At this point, you can solder the double wire closed if you want. For the wire hook pictured, I did not do any soldering on it.

Then use the round-nosed pliers to bend the doubled wire in half. I also used the round-nosed pliers to curl the end of the hook a little up. It’s not necessary, but I thought it looked a little nicer.

This finishes the hook part of your clasp.

• Introduction & Materials
• Start the Wire Hook
• Make an Unwrapped Loop
• Bend the Wire in Half
• Bend the Wire Hook Again
• Make the Wire Eye Clasp