6. Add the next two longest curls on top of the two you just wrapped, and use another clamp to hold them in place while wrapping the wire around all four pieces of wire.
7. Repeat step 6 with the shorter two curled wires, and finish wrapping the wire around the six pieces of wire. Keep wrapping until you only have a little wire left.
6. Trim off the excess and file smooth.
7. Use flat nosed pliers to tighten the wrapped wires. It should be pretty tight.
8. Now use the round nosed pliers, and curl all the end of the wire that are at the top of the tree.
9. Finally, pull the curled wire away from the middle.
10. Add a little red ribbon at the top looping it through the curls, so it can be hung from your tree.
Here's a printer friendly copy of this file.
Comments? Questions? Ideas? Share them on the jewelry making forum.
All graphics created by Tammy Powley.
