You'll need:
about 2 feet of 22 gauge sterling round wire
7 beads of your choice
3 charms
spring ring clasp
round-nosed pliers
wire cutters
flat-nosed pliers
1. Start with your first wrapped loop and insert the spring ring clasp onto the loop before closing the wrap.
2. Then about ¼ inch away from the wrap, use round nose pliers to make a loop in the wire.
4. Then use either your fingers or pliers to twist the loop one time.
6. Continue to make a wire and bead chain while you intersperse your charms. Each wire segment ends up to be almost 1 inch long (depending on the size of your beads of course), so consider this while you determine the length of your anklet. Most anklets should be at least 9 inches in length.
7. To finish the piece on the other end, make sure you make a larger loop in the last wire segment. This way you can connect the spring ring clasp to this loop.
Here's a printer friendly copy of this file.
All graphics created by Tammy Powley.
